In principle, everyone knows how to chop nuts. It would seem - nothing complicated: someone beats with a hammer, someone presses with his hands, someone uses a garlic press, and some have special devices (either home-made or purchased).
In any case, I would like to make this process as fast as possible and so that the kernel remains intact. Is it true?
Now I will show you 2 ways to chop a walnut so that the kernel remains intact.
At the end of the article, I will demonstrate this technology in a funny video in two languages :)
So, you will need:
The cut of the pipe must be even (at an angle of 90 degrees to the longitudinal axis) so that it can stand upright on its own and not fall.
The pipe diameter or profile size should be slightly smaller than the nut diameter.
Here is my last year's harvest:
Place a piece of pipe or profile vertically.
Put a walnut on top.
The joint of the two halves of the nut should be horizontal. As in the photo below.
Well, now take a hammer and strike 2 hits on the nut - from top to bottom.
After that, turn the nut 180 degrees and again beat with a hammer 2 times.
Control the force of the blow. You only need to break the shell. There is nothing difficult in this. Literally a couple of nuts - and you will get used to how hard you need to hit the nut.
After you have tapped the second side, remove the shell.
As a result, you will have such a core. Whole and unharmed.
Now I will show you the second way.
This method has only one difference from the previous one - the location of the nut on the pipe / profile.
The nut must be installed vertically (nose up) and also hit 2 times with a hammer.
Then turn the nut upside down and strike again 2 times.
Peel the nut from the cracked shell and ... Voila! You have a whole core.
Don't forget to get rid of the membrane.
Well, now, as promised - a funny video in two languages at once:
Washing machine drain pump not working? Step by step instructions on how to fix it. Might not have to buy...
A simple and reliable do-it-yourself car battery charger. Photo and Video Minimum details…
How to remove a boiled, soured brake drum of Slavuta or Tavria
16 homemade products that were familiar to every child in the USSR. Toys of children of the USSR, which were made from ...
On self-repair, I saved about 6,000 rubles. Demonstrate how to quickly repair the lock of the washing machine ...
Why do you need to know the magnitude of the current kz? What is the use of this knowledge? Turns out to be very important...
This website uses cookies.